top of page
Installation
Vertical Rod Rack
You will need the following tools:
1200mm level
Cordless drill
5mm drill bit
8mm drill bit
13mm ring spanner
Stud finder
Measuring tape
Masking tape and pencil
Masonary drill and 10mm bit if fixing to brickwork
STEP 1
-
Locate timber wall framing using a stud finder
-
You'll need two studs approximately 450mm to 600mm apart
-
Mark height of top rack approximately 1400 from the floor
-
Mark height of bottom rack approximately 300mm from the floor
-
Ensure marks are level
STEP 2
-
Drill 5mm pilot hole in centre of timber stud approx 60mm deep and install hanging bolt
-
Ensure 35mm of hanging bolt protrudes from the wall
-
If fixing to brickwork, drill a 10mm hole and insert the orange rawl plug supplied
STEP 3
-
Accurately mark the centre of the hanging bolts on the back edge of the Rod Rack
STEP 4
-
Repeat for all four hanging bolts
STEP 5
-
Drill a 5mm pilot hole through the back of the Rod Rack - A straight edge on top helps ensure the hole is drilled straight
STEP 6
-
Enlarge Pilot hole to 8mm
STEP 7
-
Slide Rod Rack over hanging bolts and secure with flat washer and nut.
STEP 8
-
Tighten nut with 13mm ring spanner
Place rods in Rod Rack
bottom of page